Fig. 192
BA ET16 de* 1.0 * et16b510.fm
Working on slopes
WARNING
Tipping hazard of machine on slopes!
A tipping machine can cause serious injury or death.
► Secure slopes before beginning work. Pay attention to ground
conditions, machine weight, etc.
► Stabilize the machine with the stabilizer blade during excavation work.
NOTICE
Lifting arm cylinders can be damaged by improper operation.
► The piston rod must not touch the stabilizer blade.
Hints for digging
When planning and performing digging work, Wacker Neuson
recommends that you observe the following points:
•
Exits from pits must be outside the digging line and as level as
possible.
•
Dig by removing adjacent strips if possible.
•
Ensure that you can drive forward when driving out of the digging area
with a fully loaded bucket.
•
Perform transport trips downhill with loaded bucket in reverse
operation.
Freeing the machine
If the machine gets stuck in the ground:
•
Tilt out the bucket until the blade is vertical above the ground.
•
Lower the boom all the way.
•
Slowly tilt out the bucket.
➥ The machine is pushed backward.
•
Reverse slowly.
•
Repeat this procedure until the tracks reach firm ground.
Reverse the machine away.
Operation 5
5-51