Reducing The Width Of The Stabilizer Blade; Changing The Width Of The Stabilizer Blade; Increasing The Width Of The Stabilizer Blade - Wacker Neuson ET16 Operator's Manual

5 Operation
A
Fig. 127
A
Fig. 128
A
Fig. 129
5-18

Changing the width of the stabilizer blade

NOTICE
Damage to machine when travelling through passages.
► The dozer blade and telescopic travel gear must have the same width.

Reducing the width of the stabilizer blade

1. Raise the dozer blade a little.
2. Shut off the engine and store the ignition switch key safely.
3. Pull out the bolts A left and right.
4. Screw in the dozer blade preparation B left and right.
B
5. Insert the bolts A left and right.

Increasing the width of the stabilizer blade

B
1. Start the engine.
2. Raise the dozer blade a little.
3. Pull out the bolts A left and right.
4. Fold out the dozer blade preparation B left and right.
5. Insert the bolts A left and right.
BA ET16 de* 1.0 * et16b510.fm