Transportation
2.9
Maintenance
Maintenance
BA ET16 de* 1.0 * Safety_01_0.fm
•
For the safe transportation of the machine:
- The transport vehicle must have a sufficient load capacity and
platform – see "Technical data"
- The maximum weight rating of the transport vehicle must not be
exceeded.
•
Use only lifting and fastening gear certified by a test/certification body,
observe the inspection intervals.
•
Do not use any lifting and fastening gear that is dirty, damaged or not
of sufficient size.
•
In order to secure the machine on the platform, use only the fastening
points provided for this purpose.
•
Ensure that nobody is in or on the machine during transportation.
•
Observe the national regulations (for example "Merkheft Erdbaumas-
chinen", leaflet on earth moving machines of the German employers'
liability insurance association for construction engineering).
•
Bear in mind the weather conditions (for example ice, snow).
•
Ensure the minimum load on the steering axle(s) of the transport
vehicle, and ensure an even load distribution.
•
Observe the intervals prescribed by law and those specified in this
Operator's Manual for routine checks/inspections and maintenance.
•
For inspection and maintenance, ensure that all tools and service
center equipment are adapted to the performance of the task
described in this Operator's Manual.
•
Do not use any damaged or malfunctioning tools.
•
Have hydraulic hoses replaced within stipulated intervals even if no
visual defects can be detected.
•
The machine and the engine must be stopped during maintenance.
•
Once maintenance is over, correctly install safety equipment again that
has been removed.
•
Wait for the machine to cool down before touching components.
Safety 2
2-13