Table of Contents
Advertisement
The system configuration dictates how many RPIs are required.
Installing an RPI unit
1.
Mount the RPI as described in "Mounting the remote power interconnect
unit" on page 25.
2.
Wire the RPI as described in "Wiring the RPI unit" on page 27.
Mounting the remote power interconnect unit
Figure 10 : RPI mounting holes
1 in.
Note: Mounting hardware is not supplied.
Installing the hardware Page 25 of 220
WARNING!
Do not power up the RPI until the
installation is complete, including the
installation of Base Station cross-
connectors.
If you are adding extra lines for Base
Stations, always power down the RPI
before you begin.
13 in.
13
/
in.
11
16
keyholes
Meridian Companion Installation and Maintenance Guide
1
/
in.
1
4
12 in.
Advertisement
Table of Contents
Troubleshooting
