Table of Contents
Advertisement
Page 166 of 220 Maintenance
Replacing a defective Remote Access Device
Replacing a defective Administration Terminal
Portable
Entering codes for system replacement and recovery
553-3601-200 Standard 7.00 November 1998
6.
Place the new power supply unit and fasten its screws.
7.
Connect the jumper lead, grounding plates, grounding strap, and cable
from the connector board.
8.
Close the cover.
9.
Plug the RPI power cord into the AC outlet.
10.
Reenable the TCM ports associated with the RPI using the instructions
in "TCM Status" on page 134.
11.
Perform reevaluation if necessary.
Remove it, then replace it with a new unit following instructions in "Installing
a Remote Access Device" on page 46.
A system Administration Terminal that cannot access the Meridian
Companion system may be defective. To replace the defective terminal,
disconnect its telephone cord, then install a new terminal using the instructions
in "Installing a Companion Administration Terminal" on page 41.
To replace a portable
1.
Deregister the portable from all systems to which it is registered.
Note: If the portable is deregistered outside the range of a system, it is
necessary to perform deregistration of the appropriate ports on the
system prior to attempting to register another portable.
2.
Register the new portable following the instructions in "Registering
portable telephones" on page 121.
A Regression Code restores an original System Security Number (SSN).
UTAM Activation Codes and Portable Credit Codes only work with the
original SSN. A Regression Code cannot be reused. You may need a
Regression Code if one of the following conditions occurs:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Meridian 1 and is the answer not in the manual?