Table of Contents
Advertisement
Page 150 of 220 Maintenance
Activating a disabled system
553-3601-200 Standard 7.00 November 1998
2.
Record the UTAM Activation Code in Meridian Companion
Programming and Provisioning Record.
Press ƒ••‚ and enter the Installer password. The display
3.
shows A. Configuration.
Press ^ then press & . The display shows
4.
4. Software Codes
Press ^ . The display shows
5.
Press * . The display shows Codes .
6.
Press ^ . The display shows Code 1: . Enter the first code
7.
number. Use BKSP for corrections.
8.
Press OK . The display shows
9.
Press OK . The display shows
10.
Press OK . The display shows
Note: If the code entry is unsuccessful, the display shows
Invalid code
Northern Telecom Customer Response Center
(1-800-321-2649) for assistance.
11.
Follow the procedure "Verifying Radio Credits" on page 182 or press
® to exit.
A disabled wireless system implies that Base Stations and portables are not
operational.
A disabled system could occur after a power interruption to the system (see
UTAM test failed
alarm
If performing the actions described in Table 42 does not correct the problem,
a UTAM Recovery Code will be required to bring the system back online.
To obtain and enter a code
1.
Call Northern Telecom Customer Response Center (1-800-321-2649) to
get a UTAM Recovery Code.
.
SSN:nnnnnnnn
Code 2:
. Enter the second code number.
Code 3:
. Enter the third code number.
Entry Successful , then Codes
. If this happens, reenter the code or call
in Table 42 on page 183 for more information).
.
.
Advertisement
Table of Contents
Troubleshooting
