Changing The Registration Password - Northern Telecom Meridian 1 Installation And Maintenance Manual

7. Press OK to confirm the new password. The display shows Re-enter: .
8. Reenter the new password and press OK . The display shows
Password changed .
If the display shows Pswd not changed , you did not enter the same
password again. Go back to step 5.
9. Record the new password in Meridian Companion Programming and
Provisioning Record.
Press ® to exit or press * to continue in Administration
10.
programming.

Changing the Registration password

You must enter the Registration password on each portable to successfully
register it with the Companion system. The default password is
‡¤‹›fl (or ÂÅÎÈØ ), but you should set your own password.
You can choose any combination of one to six digits. You will find it easier to
remember the password if the numbers correspond to a word.
You should change the Registration password after the
system is installed to protect the integrity of the settings and
to avoid adjacent systems from having the same password.
To prevent unauthorized access, provide the Registration
password only to selected personnel.
Press ƒ••· . The display shows Password: .
1.
2. Enter the Administration password. The display shows
1. Registration .
Press * until the display shows 4. Passwords .
3.
Press ^ . The display shows Admin. password .
4.
Press * . The display shows Reg. password .
5.
6. Press CHANGE . The display shows New pswd: .
Programming the Meridian Companion system Page 91 of 220
ATTENTION!
Meridian Companion Installation and Maintenance Guide