Ending A Programming Session; Recording And Reporting Alarm Messages - Northern Telecom Meridian 1 Installation And Maintenance Manual

Ending a programming session

To end Configuration programming or an Administration session, press ®
. The display shows End of session .

Recording and reporting alarm messages

Alarm messages appear on the display of the Administration Terminal when
the Meridian Companion system generates an alarm. Your Meridian
Companion supplier can interpret these messages to detect problems affecting
system operation. The Administration Terminal must be connected to port 00
on the Controller to receive alarm messages.
This is an example of an alarm message:
See Table 42 on page 183 for other alarm messages.
If an alarm message appears on the Administration Terminal's
display
1.
2.
3.
4.
Programming the Meridian Companion system Page 77 of 220
Note: You can also enter an Administration session using the
Configuration password. Once you complete steps 1 and 2 in
"Entering a Configuration programming session" on page 76,
press * then ^ . The display shows
1. Registration .
Alarm: 51-3
TIME CLEAR
Record the alarm message in Meridian Companion Programming and
Provisioning Record.
Press TIME and record the time and date displayed.
Press CLEAR to clear the alarm.
Call the system support representative to report the alarm message.
Meridian Companion Installation and Maintenance Guide