Northern Telecom Meridian 1 Installation And Maintenance Manual page 81

You must enter the Memory Reset code no later than 15 minutes after the
Meridian Companion system has been powered up. If you enter the Memory
Reset code at any time after the 15-minute interval, you hear an error tone, and
Startup denied
the display shows
powered up the system, remove and reinsert the CMCC to prepare for Memory
Reset.
Performing Memory Reset
Press ƒ , then ••
1.
Enter the Installer password. The default password is ‚‚‚‚ .
2.
If the password is correct, the display shows
If the password is incorrect, the display shows
RETRY
and enter the password again.
Memory Reset will erase your system data!
Pressing Yes returns all the data in your system to the factory
defaults. To exit with no impact on your system data, press
YES
3. Press to reset the memory. The display shows
Defaults applied and
. If 15 minutes have elapsed since you
⁄
ATTENTION!
system initialization begins.
Meridian Companion Installation and Maintenance Guide
System initialization Page 71 of 220
. The display shows
Erase all data?
Password:
Password:
.
.
. Press
®.