Configuring The Meridian 1 For The Meridian Companion System - Northern Telecom Meridian 1 Installation And Maintenance Manual

Configuring the Meridian 1 for the
Meridian Companion system
Table 15 : LD 97—Changing the ringer default parameters
Prompt
REQ
TYPE
XPEC
LOC
MED
RGTP
Configuring portable telephones on a Meridian 1 system is similar to setting up
2500 telephones. You need to be familiar with the 2500 set configuration before
you configure the Meridian 1 for the Meridian Companion system. If you have
never configured 2500 sets on a Meridian 1 system, review the installation
procedures in Meridian 1 System Installation Procedures before working with
Meridian Companion portable telephones.
1. Verify the card status of the Meridian 1 system.
2. Change the ringer default using Table 15.
The ringer default determines the maximum number of telephones that
can be in the ringing state at the same time. For analog phones, change the
ringer default from 8 to 16 to ensure that portable telephones ring when
receiving incoming calls.
Response
CHG
XPE
0, 1-95, xx
xxxxxx
<cr>
(8), 16
change or print peripheral equipment parameters
shelf controller and super loop configuration
assigns shelf controller number
location code for shelf controller
connection media
16 set to concurrent ringers
Meridian Companion Installation and Maintenance Guide
Page 103 of 220
Meaning