Table of Contents
Advertisement
Page 130 of 220 Maintenance
Card Status
553-3601-200 Standard 7.00 November 1998
The Card Status feature enables you to check the card type and state and
perform card level maintenance actions.
Press ƒ••‚ and enter the Installer password.
1.
From A. Configuration, press * until the display shows
2.
C. Maintenance .
Press ^ , then press * until the display shows
3.
2. Card Status .
Press ^ . The display shows Show card .
4.
You can enter a number or press ^ to see the first card. The
5.
display shows Cnn: followed by the card type: CMCC ,
CMBC.
Press ^ to see the firmware version of the current card.
6.
7.
Press STATE to see the card state described in Table 35.
Note: Pressing TYPE at any point resets the display to show the card
number and type, as indicated in step 5.
Press * and & to view other cards.
8.
Press ® to exit, or % to continue in Maintenance
9.
programming.
Note: The card can be disabled if the state is Busy , Failed , Idle , or
Wait Idle. Pressing DSBL shows the question
once?
the Disabling state), or CHANGE (you are asked whether to
disable upon idle; a YES response places the card in the Wait
Idle state).
on the display. You can select either YES (the card enters
CMRC
, CMLC, or
Disable at
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Meridian 1 and is the answer not in the manual?
Questions and answers