Portable Telephone Side Tone - Northern Telecom Meridian 1 Installation And Maintenance Manual

value represents a gain; a negative value represents a loss. If a value outside
the valid range is entered, the closest valid value is used.
Adjusting gain values
Press ƒ••‚ and enter the Installer password.
1.
From A. Configuration, press ^ . The display shows
2.
1. Telephony Data .
Press ^ , then * until the display shows
3.
B03 Gain Values .
Press ^ . The display shows PBX - CPP: followed by the
4.
current value.
5. Press CHANGE to enter a new value.
6. Press +/- to indicate a negative or positive value.
7. Enter the digits. Remember that digits appear without decimal points.
Press BKSP to make corrections. Press OK when you have entered the
value.
Press * to search for the next signal path.
8.
Press ® to exit or press * to continue setting programming
9.
features.

Portable telephone side tone

This option enables (you can hear your own voice when using the portable) or
disables (you cannot hear your own voice when using the portable) the side
tone. The default setting at installation is On (side tone enabled). This is the
proper setting for most installations. If required, you can change the setting by
following this procedure:
Press ƒ••‚ and enter the Installer password.
1.
From A. Configuration , press ^ . The display shows
2.
1. Telephony Data .
Press ^ then * until the display shows Side tone: .
3.
4. Press CHANGE to switch between On (side tone enabled) and Off (side
tone disabled).
Programming the Meridian Companion system Page 81 of 220
Meridian Companion Installation and Maintenance Guide