HikRobot CoaXPress User Manual page 75

Parameter
Device Uptime (s)
Board Device Type
TEC Enable
TEC Temperature
Device Temperature
Selector
Device Temperature
Fan Control Mode
Fan Speed
Device Command
Timeout
CoaXPress Area Scan Camera
Read/Write
Read only
Read only
Read and write Check it to enable TEC function.
Read and write
Read and write
Read only
Read and write
Read and write
Read only
User Manual
·
Description
It is the period of time when device is powered
up.
It is the device type.
It sets the max. temperature of sensor.
If actual sensor's temperature is lower than this
parameter, and TEC function is not enabled.
If actual sensor's temperature is higher than this
parameter and TEC enable is enabled, and then
TEC function is enabled.
It selects device temperature, including sensor
and mainboard.
It displays the real-time temperature of the
device component you selected in Device
Temperature Selector.
It sets the fan mode.
In auto mode, it includes three-level fan speed:
70, 85 and 100. According to the difference
between the configured sensor temperature
(TEC Temperature parameter) and the actual
temperature, adjustment is made every 30
seconds. If actual temperature - configured
temperature > 2 degrees, fan speed will
increase. Otherwise, fan speed will decrease.
In manual mode, the fan speed is decided by
value set in Fan Speed.
It sets the fan speed, and its range is from 40 to
100.
It counts the timeout of command.
66