Table of Contents
Advertisement
VACON® 1000
Operating Guide
4 Receiving the Delivery
4.1 Checking the Delivery
1.
Before unpacking, check the number of packing boxes according to the shipping list and then check whether the appear-
ance of the packing boxes is in good condition.
2.
After removing the packaging, check the product and enclosed documents according to the shipping list to see whether
anything is missing or does not match the order. Compare the type code for the order to the type code on the package
label. See
3.5 Type Code
-
If the delivery does not agree with the order, speak to the vendor immediately.
3.
Examine the product for any transport damage.
-
If the drive was damaged during the shipping, speak to the cargo insurance company or the carrier.
4.2 Storage
The storage temperature range of the VACON® 1000 drive is between -40°C to 70°C, and the relative humidity must not exceed 95%.
The storage environment must be out of direct sunlight, corrosion, inflammable gas, conductive dust, salt smog, oil smoke, and so
on.
Keep the equipment sealed in its packaging until installation. In its packaging, the drive can be stored in a dry and ventilated place
for more than one year. If the drive is required to be stored for a longer period, contact Danfoss.
If the drive is unpacked, apply desiccant on the drive when stored again. The wrapped product with VCI bag can be put on the
wooden pallet and stored for more than one year in a dry and ventilated place.
4.3 Lifting and Moving the Drive
LIFTING HEAVY EQUIPMENT
Follow local safety regulations for lifting heavy weights. Failure to follow recommendations and local safety regulations can result
in death or serious injury.
-
Ensure that the lifting equipment is in proper working condition.
Move the cabinets in vertical position. To lift the cabinets, use a lifting device that can lift the weight of the cabinets. Refer to the
shipping marks on the package for more information, such as weight, center of gravity, and lifting positions.
Move the drive to the installation location before removing the packaging material.
VACON® 1000 standalone cabinets are delivered in one piece, but line-up designs are delivered in separate sections:
•
Control cabinet
•
Power cell cabinet
•
Transformer cabinet
•
Options cabinet
To divide the weight of the cabinets equally, and to prevent damage to the equipment, always use 4 lifting holes. Align the lifting
locations with the center of gravity, which is marked on the package.
Move the cabinets slowly and carefully. Switchgear parts can easily fall because their center of gravity is high up at the back of the
cabinets.
4.3.1 Lifting the Standalone Cabinets
After the packaging of the cabinets is removed, a crane or forklift is required to lift them off the wooden pallets and to the installa-
tion location.
1.
Use a crane to lift the cabinet from the bottom.
The distance (D) between crane hook and cabinet top must be more than 1.5 m (4.92 ft).
The minimum angle between two lifting ropes must be 45°.
38 | Danfoss A/S © 2021.06
Description.
W A R N I N G
Receiving the Delivery
AQ363633621020en-000201 / 172F3117
Advertisement
Table of Contents
