Enter/Exit Programming Mode
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks
keyboard connection in order to transmit data to host. The selectable range
for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of
ten milliseconds. See
examples for setting this feature.
Set Wedge Quiet Interval
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can
then start again at the beginning.
DEFAULT
46
page 286
in "References" for detailed information and
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then
the bar code at left followed by the digits from
the Alphanumeric characters in
Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT bar code
again.
0A = Quiet Interval is
100 milliseconds
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Appendix D,
CANCEL