Bc9Xx0 Configuration; Interface Selection; Setting The Interface - Datalogic PowerScan 9501-AR Series Product Reference Manual

Setup

BC9xx0 Configuration

The BC9xx0 configuration can be performed in three ways: by using the
Datalogic Aladdin
tion strings from the Host PC via the RS-232 or USB-COM interface or by
reading configuration bar codes with the PowerScan
Serial Configuration
By connecting the BC9xx0 to a PC through an RS-232 or USB-COM interface
cable it is possible to send configuration strings from the PC to BC9xx0.
Configuration Bar Codes
Link the cradle and the reader using the procedures described in the Power-
™
Scan
complete, you can configure the BC9xx0 cradle by reading configuration bar
codes in this manual.
To configure the BC9xx0 using the PowerScan
the cradle with the Bind command), follow the procedure according to the
interface selected.

Interface Selection

Upon completing the physical connection between the reader and its host,
proceed to
nected to (for example: RS-232, Keyboard Wedge, USB, etc.). Scan the
appropriate bar code in that section to configure your system's correct
interface type.

Setting the Interface

Scan the programming bar code from this section which selects the appro-
priate interface type matching the system the reader will be connected to.
Next, proceed to the corresponding section in this manual (also listed in
Table 2 on page
ated with that interface.
14
™
software configuration program, by sending configura-
PM9501-AR or PBT9501-AR Quick Reference. Once the pairing is
Table 2 on page 15
15) to configure any desired settings and features associ-
Unlike some programming features and options, interface selections
require that you scan only one programming bar code label. DO NOT scan
an ENTER/EXIT bar code prior to scanning an interface selection bar
code.
Some interfaces require the scanner to start in the disabled state when
powered up. If additional scanner configuration is desired while in this
state, pull the trigger and hold it for five seconds. The scanner will
change to a state that allows programming with bar codes.
™
9501-AR reader (paired to
to select the interface type the reader is con-
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
™
9501-AR reader.