Base Address Stamping; Base Address Delimiter Character - Datalogic PowerScan 9501-AR Series Product Reference Manual

Base Address Stamping

Enables/disables the ability of base address information to be transmitted
to the host and, if so, at what position with respect to the label data. See
page 304
this feature.
DEFAULT
Base Address Transmission = Prefix

Base Address Delimiter Character

This option specifies the delimiter character to be placed between the label
data and base address when address stamping is enabled.
Set Base Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
Product Reference Guide
in "References" for detailed information and examples for setting
This feature only applies if
page 245 is enabled.
00 = No Delimiter Character
Enter/Exit Programming Mode
Base Address Transmission = Do Not Include
"Base Address Stamping"
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character. End by scanning the
ENTER/EXIT bar code again.
CANCEL
on
repre-
245