Table of Contents
Advertisement
Enter/Exit Programming Mode
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK charac-
ter from the host following label transmission. The selectable timeout range
is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments. A
selection of 0 disables the timeout.
See
page 282
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
36
for more information on setting this feature.
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
01 ACK NAK Timeout value is 200ms
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Appendix D, Keypad
CANCEL
repre-
Advertisement
Table of Contents
