Rs-485 Cradle Address; Rs-485 Slave Minimum Address - Datalogic PowerScan 9501-AR Series Product Reference Manual

RS-485 Cradle Address

Specifies the Address for the Cradle in the RS-485 network.
Set Cradle Address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

RS-485 Slave Minimum Address

Specifies the minimum address that can be set for a Cradle in an RS-485
network.
The maximum number of cradles in a single network is 16 (including the Master if
present). All cradles in the system must have different addresses.
Slave Minimum Address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by four digits from the Alpha-
Appendix D, Keypad
numeric characters in
resenting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
CANCEL
.
repre-
rep-
247