Table of Contents
Advertisement
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
Determine the desired character or value.
Enable Character is not used (not available).
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the bar code: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 34. Enable Character Setting Examples
STEP
ACTION
1
Desired character/value
Hex equivalent from
2
ASCII Chart
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT ENABLE CHARACTER VALUE SETTING
Scan Two Characters
From Appendix D,
5
Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Setting to previously defined characters such as XON, XOFF,
or host commands conflicts with normal operation of these
characters.
ASCII Chart
on the inside back cover of this manual to find the
hex equivalent for the desired character/value.
page 40
and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
Appendix D,
Keypad, that represent the desired character/value in step
2 above. The second character will cause a two-beep indication.
ming Mode.
EXAMPLES
'e'
0x65
'6' and '5'
A setting of 0xFF indicates the
Table 34
for some examples of how to
'}'
'E'
0x7D
0x45
'7' and 'D'
'4' and '5'
RS-232 Parameters
Enable Command
Not Used
0xFF
'F' AND 'F'
285
Advertisement
Table of Contents
