Enter/Exit Programming Mode
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
220
This feature only applies if
sion"
on page 219 is enabled.
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
00 = No Delimiter Character
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
"Source Radio Address Transmis-
Appendix D, Keypad
CANCEL
repre-