Datalogic PowerScan 9501-AR Series Product Reference Manual page 300

References
Set Length 2
This feature allows you to set one of the bar code lengths for the specified
symbology. Length 2 is the maximum label length if in
Mode, or the second fixed length if in
the specific symbology for parameters.
The length that can be set varies depending on the symbology. A setting of
0 specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore
2. Go to the Set Length page for your selected symbology and scan the
3. Scan the bar code to SELECT LENGTH 2 SETTING for your selected sym-
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure.
290
this length). Pad the number with leading zeroes to yield two digits. For
example: 0 = 00, 5 = 05, 20 = 20, etc.
ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
bology.
that represent the length setting which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake, before the last character scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
Fixed Length
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Variable Length
Mode. See the page for
Appendix D, Keypad