Configure Actions For F4 (16-Key Models Only); Configure Actions For Shift (16-Key Models Only) - Datalogic PowerScan 9501-AR Series Product Reference Manual

Configure Actions for F4 (16-key models only)

DEFAULT
Configure Actions for F4

Configure Actions for Shift (16-key models only)

DEFAULT
Configure Actions for Shift
Product Reference Guide
Enter/Exit Programming Mode
F4 No Actions Configured
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code for the Function Key you want to program. Next
scan 4 digits from the Alphanumeric characters in
Appendix D, Keypad
.
The first digit must be 0; the following 3 digits must
be configured according to the CMD_ID numbers in
Table 27 on page 257
ENTER/EXIT bar code again.
Shift No Actions Configured
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code for the Function Key you want to program. Next
scan 4 digits from the Alphanumeric characters in
Appendix D, Keypad
.
The first digit must be 0; the following 3 digits must
be configured according to the CMD_ID numbers in
Table 27 on page 257
ENTER/EXIT bar code again.
. End by scanning the
. End by scanning the
261