Table of Contents
Advertisement
This and following sections provide programming bar codes to configure
your reader by changing the default settings. For details about additional
methods of programming, see
Configuration Parameters
Once the reader is set up, you can change the default parameters to meet
your application needs. Refer to
initial configuration in order to set the default values and select the interface
for your application.
The following configuration parameters are divided into logical groups,
making it easy to find the desired function based on its reference group.
Interface Configuration:
•
•
•
Parameters Common to all Interface Applications:
•
•
Wireless-Only Features
•
•
•
•
Product Reference Guide
Configuration Using Bar Codes
You must first enable your PowerScan to read bar codes in order to
use this section. If you have not done this, go to
on page 7
"RS-232 Only Interface"
"RS-232/USB-Com Interfaces"
"Keyboard EMULATION Settings"
"Data Format"
on page 53 gives options to control the messages sent to
the Host system by selecting parameters to control the message strings
sent to the handheld.
"Reading Parameters"
indicators status functioning such as programming for scanning,
beeper and LED indicators and other universal settings.
"Wireless Features"
on page 207:
"PBT9501-AR-Only Features"
"PM9501-AR-Only Features"
"Display and Keyboard Features"
"Configuration Methods" on page
and complete the appropriate procedure.
"Standard Defaults"
on page 27
on page 31
on page 41
on page 69 control various operating modes and
on page 226
on page 238
on page 251
Chapter 3
6.
Setup, starting
starting on page 325 for
23
Advertisement
Table of Contents
