Table of Contents
Advertisement
RS-232/USB COM Parameters
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one
character and the beginning of the next. The delay can be set within a range
of zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-
fies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
4. Go to
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure. See
set this feature.
Table 28. Intercharacter Delay Setting Examples
STEP
ACTION
1
Desired Setting
Divide by 10 (pad with
2
leading zeroes to yield
two-digits)
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT INTERCHARACTER DELAY SETTING
Scan Two Characters
From Appendix D,
5
Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
the result with leading zeroes to yield two digits. For example: 0 = 00,
5 = 05, 20 = 20, etc.
ming Mode.
page 32
and scan the bar code: SELECT INTERCHARACTER DELAY
SETTING.
pad, that represent the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
EXAMPLES
50ms
05
'0' and '5'
Table 28
for some examples of how to
150ms
600ms
15
60
'5' and '0'
'6' and '0'
RS-232 Parameters
Appendix D, Key-
850ms
85
'8' and '5'
279
Advertisement
Table of Contents
