1. Bolt (1/2 x 3–1/2 inches)
(4)
2. Flat washer (4)
3. Pivot bracket, notch facing
up (4)
Attaching the Rollbar
1. Insert the cylindrical spacer in the pivot holes in both
rollbar supports (Figure 6).
g017920
1. Cylindrical spacer
2. Lift the rollbar with the cutouts in ends of the
tube facing up and align the pivot holes with the
cylindrical spacers in the rollbar supports.
Note: A second person to perform the next step
will be helpful.
3. Attach the rollbar to the rollbar supports as shown in
Figure 7. Leave the bolts just loose enough to allow
the rollbar to freely pivot.
Figure 5
4. Flat spacer (4)
5. Flange locknut (4)
6. Rollbar, cutout facing
down
Figure 6
2. Large pivot hole
Note: Ensure that the tab to which the lanyard is
attached is angled away from the surface of the pivot
bracket.
1. Bolt (1/2 x 3–1/2 inch) (2)
2. Pivot pin with hairpin and
lanyard (2)
4. Raise the rollbar into the upright position and lock it
in place with both pivot pins as shown in Figure 8.
1. Rollbar
2. Pivot pin
Making Final Adjustments
1. Tighten the fasteners in the order specified in the
following table. Figure 4 and Figure 5 will help
identify the parts.
5
Figure 7
3. Flange locknut (2)
Figure 8
3. Hairpin
4. Rollbar, upright and locked