GE Voluson E Series Service Manual page 71

3.4.7.2 Adjustment of the USB Video Recorder Settings
Note Make sure that the Ext. Monitor video signal is set to DVI; see
Basic Functions of Setting Buttons
Parameters can be set using the display and buttons at the front of the USB video recorder.
Menu selection
When changing a parameter setting
Check and match Default Settings
□ TOP MENU - MEDIA FORMAT: FAT32
1. Press the O Enter button on the front of the USB video recorder for min. 4 seconds.
2. Press the [↑] or [↓] button to select [MEDIA FORMAT] and then press O Enter.
3. Press the [↑] or [↓] button to select [FAT32] and then press O Enter.
□ TOP MENU - SETTING - 01 REC SETTING - 11 INPUT: DVI -SXGA
1. Press the O Enter button on the front of the USB video recorder for min. 4 seconds.
2. Press the [↑] or [↓] button to select [SETTING] and then press O Enter.
3. Press the [↑] or [↓] button to select [REC SETTING] and then press O Enter.
4. Press the [↑] or [↓] button to select [INPUT] and then press O Enter.
5. Press the [↑] or [↓] button to select [DVI - SXGA] and then press O Enter.
□ TOP MENU - SETTING - 01 REC SETTING - 12 MODE: High - FAT32
1. Press the O Enter button on the front of the USB video recorder for min. 4 seconds.
2. Press the [↑] or [↓] button to select [SETTINGS] and then press O Enter.
3. Press the [↑] or [↓] button to select [REC SETTING] and then press O Enter.
4. Press the [↑] or [↓] button to select [MODE] and then press O Enter.
5. Press the [↑] or [↓] button to select [High - FAT32] and then press O Enter.
Voluson E-Series Service Manual
KTD106657 Revision 2
Setup Instructions
Section 3.7.1.7 on page 3-60 .
3-27