GE Voluson E Series Service Manual page 346

Care and Maintenance
10.4.2.2 Peripheral/Option Checks
If any peripherals or options are not part of the ultrasound system configuration, the check can be omitted.
Refer to Section 3.8 "On-board optional Peripherals" on page 3-62
Table 10-5 approved peripheral/hardware option functional checks
Step Item
1 Media
2 B/W Printer
3 Color Printer
4 Color Deskjet
(Bluetooth) Printer
5 DICOM
6 Footswitch
7 ECG
8 Cellular Modem
10.4.2.3 Mains Cable Inspection
Step Item
1 Unplug Cord
2 Inspect
3 Verify
4 Verify
10-6
Description
Verify media drive(s) read/write properly. Clean if necessary.
Verify hardcopy output of the B/W video page printer. Clean heads and covers if necessary.
Verify hardcopy output of the Color video page printer. Clean heads and covers if necessary.
Verify hardcopy output of the Deskjet (Bluetooth) printer. Clean heads and covers if necessary.
Verify that DICOM is functioning properly. Send an image to a DICOM device.
Verify that the footswitch is functioning as programed. Clean as necessary.
Verify basic operation with customer.
Verify basic operation.
Table 10-6 mains cable inspection, as appropriate
Description
Disconnect the mains cable from the wall and ultrasound system.
Inspect it and its connectors for damage of any kind.
Verify that the LINE, NEUTRAL and GROUND wires are properly attached to the terminals, and that
no strands may cause a short circuit.
Inlet connector retainer is functional.
for a list of approved peripherals.
Voluson E-Series Service Manual
KTD106657 Revision 2