Table of Contents
Advertisement
Setup Instructions
3.13.2.3 Adding a WLAN Profile
1.
Press the Utilities key on the control console.
2.
On the left side of the screen select
3.
Click the
4.
The Wireless Network Configuration tool with available Wireless Networks appear.
5.
Select the
6.
Add the following information to the Wireless Network Properties page:
-
Network Name (SSID)
-
Check box "Connect even if Network is not Broadcasting its Name (SSID)"
-
Network Authentication (Open, Shared Key, WPA PSK or WPA2 PSK)
-
Data Encryption
-
Network Key
-
Key Index
7.
After you have filled in all the required information, click
3.13.2.4 Refreshing a WLAN Network
1.
Press the Utilities key on the control console.
2.
On the left side of the screen select
3.
Click the
4.
The Wireless Network Configuration tool with available Wireless Networks appear.
Refresh .
5.
Click
3.13.2.5 Setting a WLAN Network as Non-Preferable
When you make a WLAN non-preferable, you disconnect the network from the system and delete all
connection settings from the system. Afterwards the system WILL NOT try to reconnect to this WLAN
automatically. And if you want to reconnect, you will need to re-add this WLAN.
1.
Press the Utilities key on the control console.
2.
On the left side of the screen select
3.
Click the
4.
The Wireless Network Configuration tool with available Wireless Networks appear.
5.
Highlight the wireless network you want to set as non-preferred.
Make Non-Preferable and confirm the message box.
6.
Click
3-72
Connectivity and then click the Device Setup tab.
WLAN Configuration button; see
Security tab and then click Add .
Figure 3-68 Security - Add
Connectivity and then click the Device Setup tab.
WLAN Configuration button; see
Connectivity and then click the Device Setup tab.
WLAN Configuration button; see
Figure 3-65 on page 3-70
.
OK .
Figure 3-65 on page 3-70
.
Figure 3-65 on page 3-70
.
Voluson E-Series Service Manual
KTD106657 Revision 2
Advertisement
Chapters
Table of Contents
Troubleshooting
