GE Voluson E Series Service Manual page 347

10.4.3 Physical Inspection
Step Item
1 Labeling
2 Covers
3 Control Console
and Keyboard
4 Control Console
Movement
5 Control Console
Lighting
6 LCD Monitor
7 Monitor Light
8 Cables and
Connectors
9 Shielding & Covers
10 Probe Holders
11 Power and System
Status Indicators
12 External I/O
13 Wheels and Brakes • Check all wheels and casters for wear and verify operation of foot brake, to stop the system from
14 Battery
Voluson E-Series Service Manual
KTD106657 Revision 2
Table 10-7 physical checks
Description
Verify that all ultrasound system labeling is present and in readable condition.
Where applicable, verify all covers are secured in place and are properly aligned with other covers.
Replace any covers that are damaged.
Inspect the control console and keyboard. Record any damaged or missing items. (Replace faulty
components, as required).
• Where applicable, verify ease of control console movement in all acceptable directions.
• Where applicable, ensure that it latches in position as required.
Check proper operation of all control console and TGC lights.
Inspect the LCD Display for scratches and bad pixels. Verify proper operation of Contrast and
Brightness controls. Where applicable, confirm that the LCD arm allows:
• swivelling the screen to the left and to the right
• folding the screen to the locked position
• release and adjustment backwards and forwards
• can be adjusted in the up/down positions
Note: LCD Arm movement may vary and is not applicable to all ultrasound systems.
Check for proper operation of any monitor lights, if available.
Check all internal cable harnesses and connectors for wear and secure connector seating. Pay
special attention to footswitch assembly and probe strain or bend reliefs.
Check to ensure that all EMI shielding, internal covers, air flow panels and screws are in place.
Missing covers and hardware could cause EMI/RFI problems during scanning.
Where applicable, inspect the Probe Holders for cracks or damage.
Check for proper operation of all Power and System Status Indicators.
Check all connectors for damage and verify that the labeling is good.
moving, and release mechanism.
• Check all wheel locks and wheel swivel locks for proper operation.
Where applicable, check that the battery is not damaged, does not leak, does not emit an odor, and is
not deformed or discolored. Observe all warnings and cautions for battery handling, recharging,
storing, and/or disposal.
Care and Maintenance
10-7