Setup Reminders; Average Installation Time; Installation Warnings - GE Voluson E Series Service Manual

Setup Instructions

3.1 Setup Reminders

3.1.1 Average Installation Time

Once the site has been prepared, the average installation time required is shown in Table 3-1 below.
Description
Unpacking the system
Installing the system / options / printers
DICOM Option (connectivity)
Install InSite

3.1.2 Installation Warnings

Caution
Since the Voluson E-Series weighs approximately 130 kg (286.6 lbs.) without peripherals, two people are
required to unpack it.
Warning
There are no operator serviceable components. To prevent shock, do not remove any covers or panels.
Should problems or malfunctions occur, unplug the power cord.
Only qualified service personnel should carry out servicing and troubleshooting.
3.1.2.1 Moving/Lifting the System
Note For important safety considerations see
Figure 3-1 lifting the system
Caution
•
Do not pull or lift the system with the front handle of the user interface (control console).
•
Always use a strap to lift the system. Do not grasp the metal sheet with your hands.
•
Move the system forward or backward when going up or down inclines. Do not move the system
sideways or diagonally.
3-2
Table 3-1 average installation time
Average Installation Time
0.5 hours
0.5 to 1.5 hours
0.5 to 1.5 hours
0.5 hours
Section 1.5.3 "Mechanical Safety" on page 1-20
How to lift the system:
1 Preparation
•
Disconnect all probes and transport them separately.
•
Disconnect the ECG cable (if applicable) and transport it separately.
•
Ensure all peripheral devices (printer, ...) are firmly fixed within the
system.
2 Remove the footrest cover on the front side of the system: Turn the 2 quick
release devices below the footrest 90° (see:
3 Pass a strap through the openings in the metal sheet.
4 Lift the system by the straps and the rear handle.
Comments
depends on required configuration
depends on configuration amount
.
Figure 8-21 on page 8-17
Voluson E-Series Service Manual
KTD106657 Revision 2
).