GE Voluson E Series Service Manual page 145

4.3.6.2 Functions after the Acquisition
Step Task
1
2
Niche
3
Ref. Image
4
Init
5
3D Init
6
SRI / SRI 3D
7
3D Orientation
8
9 Zoom
10 Mix
11 TH. low
Magi Cut
12
Render Mode
13
Voluson E-Series Service Manual
KTD106657 Revision 2
Figure 4-17 Sectional Planes and Image Rendering
Table 4-6 Functions after the 3D Acquisition
PW Mode rotary control: Rotation about X-axis of the reference image.
M Mode rotary control: Rotation about the Y-axis of the reference image.
PD Mode rotary control: Rotation about the Z-axis of the reference image.
C Mode rotary control: Movement along Z-axis of the reference image.
Trackball: Movement along X- and Y-axis of the reference image.
Parts of the orthogonal sections A, B and C are compiled to a 3D-section aspect. The
aspect shows a quasi spatial cut into the reference image.
To select the Reference image among A, B, C or 3D.
Resets rotations and translations of a volume section to the initial (start) position.
Resets the 3D image to the initial (start) position.
Speckle Reduction Imaging (SRI) to reduce speckle which interferes with the sectional
planes or rendered 3D image.
To change the image orientation of the 3D image..
The 3D image as well as the sectional planes can be varied by their aspect ratio.
To adjust the mix ratio between two calculated modes.
All color values below the level will be disregarded for calculation of the surface.
Ability to electronically manipulate the images and cut way "3D artifacts".
To select the Render Mode (Image Type and Render Algorithm)
Expected Results
SRI information.
Functional Checks
4-19