GRAPHTEC LABELROBO LCX603 User Manual page 90

Chapter 3 Printer Driver
Installing
(1) Make sure the power is switched off (  ) in this device, and then connect the AC power cord for this device.
(2) When "LCX603 Setup" in the start screen is clicked, the setup screen will appear.
Follow the instructions shown on the screen.
(3) Makes sure the LCX603 is not connected, and then click "Next".
(4) Click "Next".
3-4
Before installing the printer driver, make sure to NOT connect the interface cable between this
device (LCX603) and your computer.
• Make sure that the printer is grounded.
• If the printer is not grounded, the operator could suffer an electrical shock in case of current leakage.
→