Usage; Thermal Heads; Consumable Parts; After Use - GRAPHTEC LABELROBO LCX603 User Manual

This document contains precautions to be adhered to upon using this product. Please read it carefully prior to use.
Safety Precautions for Attaching Labels
Various functions and attributes of the label may differ depending on the conditions of the environment in which it is
used.
Before use, please be sure to confirm whether the product is appropriate for its intended use.
Precautions when affixing labels to moldings (shaped products)
In situations where labels are affixed to resin moldings, it is possible that the air bubbles from the outgas emerging out
of the resin could enter the label and cause it to soften.
As this occurs especially easily with polycarbonate, polystyrene, ABS, and acrylic, please carry out thorough testing
when using.
The following measures are not covered in the warranty.
• Use strong pressure when applying by hand.
• Change to composite paper instead of an aluminum evaporator coil mat such as the FNS KESHI N25.
• Apply strong adhesion for adhesive materials.

Thermal Heads

The temperature of the thermal head can rise easily when the surrounding environment temperature is high, and the
occurrence of a head temperature error becomes more likely during fill printing or outline character printing.
It is recommended that the product be used in an environment below 25°C.
Usage Environment
When printing is carried out in a hot and humid environment, this may cause the label materials to change and become
defective, and the separator winder to become faulty.
Furthermore, the surface of completed labels may change from flat to rounded.
Please refrain from using in a hot and humid environment.
Media
When using label materials that have been stored for a long period of time in the low-temperature environment of a
warehouse, leave them in a normal-temperature setting at least half a day before usage as the print quality is reduced
when the central interior portion of the material is chilled.

Consumable Parts

The thermal head and cross cutter unit are consumable parts. They are consumed as they are used, and must
eventually be replaced.

After Use

After use, cover the main unit with the soft cover supplied or a cloth to keep dust off.

Usage

PREFACE
V