GRAPHTEC LABELROBO LCX603 User Manual page 119

(10) Press the F2 key (X-POSITION ADJ) and enter the correction value for direction x.
X - P O S I T I O N A D J U S T
< 0 . 0 > m m
A D J U S T :
Y E S : E N T E R N O : E S C
Change the numerical value (-1.5 to +1.5) with the POSITION keys (▲ ▼) and program the correction value .
Press ENTER to confirm and return to the previous screen.
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
(11) Press the F3 key (Y-POSITION ADJ) and enter the correction value for direction y.
Y - P O S I T I O N A D J U S T
< 0 . 0 > m m
A D J U S T :
Y E S : E N T E R N O : E S C
Change the numerical value with the POSITION keys (▲ ▼) and program the correction value.
Press ENTER to confirm and return to the previous screen.
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
Verify Results After Correction -1
(1) Enter the correction values for both the X direction and the Y direction, and confirm the results.
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
(2) On the above display, press the F4 key (CUT CONFIRMATION), and the following is displayed.
C O N F I R M A D J U S T M E N T ?
Y E S : E N T E R N O : E S C
(3) Press the ENTER key, and the adjustment confirmation cut is cut on the 2nd page by the cutter pin set on the tool
carriage. Feed direction.
(4) After the cut, the following is displayed.
P O S I T I O N A D J U S T M E N T
X - P O S I T I O N A D J >
Y - P O S I T I O N A D J >
C U T C O N F I R M A T I O N >
Chapter 4 Menu Operation
4-21