GRAPHTEC LABELROBO LCX603 User Manual page 6

Safety Precautions
When disconnecting the power cord or an interface
cable, do not pull on the cord/cable.
• Such action will damage the cord/cable, resulting in a fire
hazard or electrical shock.
Do not clean the label printer using a volatile solvent
(such as thinner or benzene).
• Such action may impair its performance.
Do not attempt to lubricate the label printer's
mechanisms.
• Such action may cause it to break down.
Do not place the label printer on an incline, areas
subject to many vibrations, or other unstable
locations.
• If the label printer falls, it may sustain damage.
v
Safety Precautions
If water or foreign matter enters inside the label
printer, do not continue using it. Turn off its power and
unplug its power cord from the electrical socket.
• Use of the label printer in such a status may result in
electrical shock or a fire hazard due to current leakage.
• If the label printer requires repair, contact your sales
representative or nearest GRAHTEC vendor.
Do not place magnetic cards, diskettes or similar
items in the vicinity of the tool carriage.
• The magnetic force may destroy the data on the magnetic
cards or diskettes.
Provide sufficient space around the label printer so
that the media does not strike any objects in the label
printer's vicinity during cutting or plotting.
• Such contact may cause cutting or plotting to go out of
alignment.
When using the cutter pen, take care not to extend the
cutter blade excessively.
• An excessive blade length will damage the cutting mat and
impair the label printer's cutting quality.