Table of Contents
Advertisement
Chapter 5 Replacing Consumable Items
(10) Lock in the shaft groove and set the flange.
(11) Set the label materials and install the flange.
Set it so that the label materials are the revolute.
Push so that there is no opening in between the form tube and flange.
5-14
•
During set-up, be careful not to confuse the revolute with the involution.
•
Make sure the set label materials do not slack.
•
There is the possibility of inclining to one side if media glue attaches to the inside of the flange.
Please clean regularly. (Refer to "6.12 Cleaning Media Stocker & Media Stocker Flange".)
Advertisement
Table of Contents
Need help?
Do you have a question about the LABELROBO LCX603 and is the answer not in the manual?
Questions and answers