The Nk RBbon WrNkles; The Nk RBbon S Wound Up - GRAPHTEC LABELROBO LCX603 User Manual

The ink ribbon wrinkles
Symptom/Cause
• The ink ribbon is slack.
• It was wrinkled when the media was set.
• The head pressure adjustment plate is not properly set.
Solution
• When there is a wrinkle in the ribbon, feed it for a while.
• If the wrinkle can still not be removed, remove the ribbon stocker, remove the ink ribbon, and reset it.
• Switch the position of the head pressure adjustment plate depending on the utilized ink ribbon.
• Refer to "2.8 Setting the Ink Ribbon" for details on how to set the ink ribbon.
The ink ribbon is wound up
Symptom/Cause
• The ink ribbon is pulled by the label material, or it is wound up.
Solution
• The ink ribbon Density Settings does not match. Referring to "4.9 PRINTING DENSITY", make the optimal Density
Settings.
• Remove the media stocker, and remove the label material.
• Pull out the ribbon stocker, pull out the ink ribbon, and cut it.
Chapter 7 Troubleshooting
7-13