GRAPHTEC LABELROBO LCX603 User Manual page 14

Hide thumbs Also See for LABELROBO LCX603:
Table of Contents

Advertisement

PREFACE
Precautions when using this product
For this device, please use genuine supply products, an environmental temperature range (16-32°C, 35-70% R.H.) for
accuracy assurance and set the MEDIA TYPE.
In order to continue stable operation, please take the "Ideal Density Settings for Ink Ribbons and Label Materials (Media)"
into consideration.
If the MEDIA TYPE is set to OFF (No settings), it is possible that the values will be set to outside those given in the
Density Settings (PRINTING DENSITY) guarantee.
If used in a way not covered by the Density Settings (PRINTING DENSITY) guarantee, depending on the print data,
the printing may be satisfactory but the ink ribbon may be burned onto the print head and it may become necessary to
clean it frequently.
If genuine supply products are used, even if values outside of the Density Settings (PRINTING DENSITY) guarantee are
used, it will not cause the device to break down.
If values outside of the Density Settings (PRINTING DENSITY) guarantee are used, then the responsibility lies with the
customer.
In the case of values outside of the Density Settings (PRINTING DENSITY) guarantee being used, a warning message
will be displayed.
Precautions Regarding Installation
Please take sufficient note of the surroundings of the installation area.
Use of this device in a temperature outside the environment temperature range (16-32ºC, 35-70% R.H.) for accuracy
assurance may adversely affect printing quality.
Even should you move this unit or ink ribbons, label materials (media) or laminate materials from an environment
exhibiting a temperature outside the environment temperature range for accuracy assurance to an environment
exhibiting a temperature inside said range, use the relocated items only after leaving them dormant for a sufficient
amount of time (2 hours is ideal) to adjust to said environment.
Depending on where the unit is installed or where ink ribbons, label materials or laminate materials are stored, they may
be exposed to the likes of dirt and dust, which has the potential to negatively affect printing quality and result in product
failure.
Upon storing materials that have been partially used, remove the materials from the main unit, fully seal them inside a
plastic bag, and store them in a manner that keeps them free of outside air.
Be Sure to Read Prior to Printing
Before using the LABELROBO LCX603, please check the "Emergency Stop Switch" operation instructions.
For information on the "Emergency Stop Switch", please refer to the aforementioned "1.3 Label Printer Part Names" in
the User's Manual.
Upon setting print density, please be sure to refer to the Ideal Density Settings in Before Using the Printer (LCX603
Additional User's Manual).
Settings for print density differ between data with a high volume of fill printing (high coverage rate) and data with a high
volume of characters, etc. (low coverage rate).
Please select the appropriate print density in accordance with the data being printed.
Trial printing to verify printing quality is recommended.
Upon printing, ensure that a black ribbon is set in Head 3.
Please note that should a non-black ribbon be set in Head 3, the sensor will be unable to pick up registration marks
printed with a non-black ribbon, causing the unit to not function properly.
V

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LABELROBO LCX603 and is the answer not in the manual?

Table of Contents