Fabric Desktop End Screens - Knoll Antenna Workspaces Installation Instructions Manual

Fabric Desktop End Screens

Parts List:
Bayonet Mount Bracket (A)
Upholstered End Screen Rail Clamp (B)
/ -18 x ¾" Machine Screw (C)
5
16
Set Screw (D)
Screen Bottom Extrusion
Screen
Tools Needed:
Drill
Phillip #2 and #3 Bits
/ " Hex Bit
1
8
STEPS
Insert (2) bayonet mount brackets (A) into
1.
the top of the screen bottom extrusion so
that the holes in the brackets align with
the two sets of holes in the extrusion.
2. Insert (4) / "-18 x ¾" machine screws (C)
5
16
beneath the extrusion and firmly attach the (2)
bayonet mount brackets (A) to the extrusion.
3. Position the screen extrusion on
the end of the worksurface.
4. Insert (1) set screw (D) into the bottom of an
upholstered end screen rail clamp (B), then hook
the hook the rail clamp behind the back edge of
the worksurface so that the clamp's u-channel
is above the worksurface and the set screw is
below the worksurface. Slide one end of the
bottom screen extrusion onto the u-channel
portion to temporarily support the clamp.
(A) 3AB408200
(D) 3AB4382
5. Insert another set screw (D) into, the second
upholstered end screen rail clamp (B), then hook
it on to the front edge of the worksurface in a
similar fashion, sliding the u-channel portion into
the other end of the bottom screen extrusion.
6. Hold the U-channel portion of the rail clamps
(B) firmly against the side of the screen bottom
extrusion and tighten the set screws (D) against
the bottom of the worksurface.
NOTE
: The set screws (D) will create the
tight connection between the screen bottom
extrusion and the worksurface. The rail clamp
(B) must be seated firmly within the side of the
bottom extrusion, but should not be pressed
tight against the bottom of the worksurface.
A space will remain between the rail clamp
and the bottom of the worksurface.
(B) 3AB4363* (C) 7060440
7. Position the openings in the underside
of the screen over the bayonet mount
brackets (A) and push the screen down
until the screen is firmly seated.