Keyboard Tray Mount Kit - Knoll Antenna Workspaces Installation Instructions Manual

Keyboard Tray Mount Kit

Pattern Number Represented:
Keyboard Tray Mount Kit, YAK
Parts List:
Keyboard Support Bracket (A)
¼-14 x / " Wood Screw (B)
7
8
10–32 x ½" Machine Screw (C)
Track from KnollExtra Keyboard Arm
Tools Needed:
Drill
Phillips #2 and #3 bits
STEPS
Knoll Keyboard Tray Mount Kits
NOTE:
are intended for use with KnollExtra
Keyboard trays only.
1. Position (3) keyboard support brackets (A) on
a flat surface, oriented as shown in exploded
keyboard mount diagram at right. The sides of
the brackets with seven holes should face up.
2. Attach the track to the keyboard support
brackets (A) using (3) 10-32 x ½" machine
screws (C) for the back bracket, (2) 10-32 x
½" machine screws (C) for the center bracket
and (3) 10-32 x ½" machine screws (C) for the
front bracket. Be sure to align the brackets
with the correct holes in the track so that
two brackets will fit inside the desk rails, and
one bracket will fit outside the desk rails.
3. Position the keyboard support bracket/
track assembly under the worksurface
so that the front bracket is inset ½" -1"
from the front edge of the worksurface.
Adjust alignment as required to clear any
suspended electrical/ data components.
4. Attach the keyboard support bracket/
track assembly to the underside of the
top with (2) ¼-14 x / " wood screws
7
8
(B) per bracket (6 total screws).
Please refer to the instructions
NOTE:
packaged with the KnollExtra keyboard arm
for further instructions about arm assembly.
(A) 3AB8025111 (B) 4A214020140
Exploded Keyboard Tray
Mount Assembly
(C) 7083440
Step 2
10 - 32 x
½" Machine
Screw (C)
Track from
KnollExtra
Keyboard
Arm
Step 4
¼ - 14 x
7
Screw (B)
Keyboard
Support
Step 1
Bracket (A)
Assembled Keyboard
Tray Mount
/ " Wood
8