Pedestal Positioning Brackets - Knoll Antenna Workspaces Installation Instructions Manual

Pedestal Positioning Brackets

Pattern Numbers Represented:
YSFA
Parts List:
Pedestal Positioning Bracket (A)
#10-32 x ¾" Self Tapping Screw (B)
25"H Pedestal
Desk Assembly or
Big Table Assembly or
Bridge Assembly
Tools Needed:
Drill
Phillips #3 bit
Double Stick Tape (optional)
STEPS
1. Build desk, bridge, or big table assembly
(see desk, table desk with bridge or
big table assembly instructions).
2. Position the 25"H pedestal under the rails
of the assembly in the desired location (i.e.
adjacent to a supportive leg or pedestal.)
3. Temporarily slide (1) pedestal position bracket
(A) between the bottom of each rail and
the top of the pedestal. Take note of the
holes in the pedestal top that correspond
with the holes in the (2) brackets (A).
(A) 3AB4099*
: If there are no corresponding
Note
holes in the pedestal top, mark the
bracket locations with a pencil.
4. Remove the pedestal position brackets and
slide the pedestal out from beneath the rails.
5. Attach the (2) pedestal positioning
brackets to the top of the pedestal using
(1) #10-32 x ¾" self tapping screw (B) per
bracket in the holes previously noted.
Note: If there were no corresponding holes,
the pedestal positioning brackets may
be adhered to the pedestal top in their
marked positions with double stick tape.
(B) 6AA454996
6. Raise the glides under the pedestal until
they are fully inserted into the pedestal
case. Slide the pedestal back into its
desired position under the rails.
Note : You may have to lift the desk assembly
slightly to clear the underside of the rails.
7. Adjust the glides under the pedestal
to raise and level the pedestal, and to
engage the pedestal positioning brackets
fully with the underside of the rails.