Fabric Fence Screens - Knoll Antenna Workspaces Installation Instructions Manual

Fabric Fence Screens

Pattern Numbers Represented:
Fabric Screens for Fence, YPSF__F
Parts List:
Bayonet (A)
U-Bracket (B)
/ –18 x 1 ½" Hex Head Bolt (C)
5
16
Fabric Screen Panel
Fence Frame
Crown Covers
Tools Needed:
Drill
Phillips #2 and #3 bits
Rubber Mallet
STEPS
1. Ensure the crown covers are
installed on the Fence frame.
2. Remove the upper cover from one
side of the Fence frame.
3. Position the fabric panel in the desired location
on the fence frame and note where the openings
on the underside of the screen are located.
4. Mark the two holes in the top of the Fence
frame that are closest in location to the
openings in the bottom of the fabric screen.
(A) 3AB408300
NOTE: The holes in the top of the
Fence frame are repeated every 3".
5. Place a U-bracket (B)
inside
the top horizontal channel, at each marked hole
position. (i.e. (2) U-brackets per fabric screen.)
6. Place a bayonet (A) on top of the frame, in the
top horizontal channel, at each marked hole
position. (i.e. (2) bayonets per fabric screen.)
7. Secure each bayonet (A) to its corresponding
U-bracket (B) with a / –18 x 1 ½" hex
5
16
head bolt (C) inserted from below the top
horizontal channel of the Fence frame.
(B) 3AB405400 (C) 7231496
8. Position the openings in the underside of
the screen over the bayonets (A) and tap the
screen down lightly into position with a rubber
the frame, under
mallet until the screen is firmly seated.
9. Re-install the upper Fence cover
removed in Step 2.