Markerboard, Glass, Laminate Or Veneer Fence Screens - Knoll Antenna Workspaces Installation Instructions Manual

Markerboard, Glass, Laminate or Veneer Fence Screens

Pattern Numbers Represented:
Screens for Fence, YPSF___
Parts List:
¼-20 x 1 ¼" Hex Head Machine Screw (A)
¼-20 Serrated Flange Hex Nut (B)
/ " x 1" Roll Pin (C)
1
8
Markerboard, Glass, Laminate
or Veneer Screen Panel
Fence Frame
Crown Covers
Tools Needed:
Drill
Phillips #2 and #3 bits
STEPS
1. Ensure the crown covers are installed
on the Fence frame.
2. Remove the upper covers from one
side of the Fence frame.
3. If more than one screen is to be installed,
push (2) / " x 1" roll pins (C) half way
1
8
into the end of the first screen, on the
adjoining side. If only one screen is to be
installed, please skip ahead to step 4.
4. Slide the heads of the ¼-20 x 1 ¼" hex
head machine screws (A) into the extruded
aluminum slot at the bottom of the screen
panel. Depending on the size of the panel
there will be (2 to 4) screws (A) required.
(A) 6AA462100
5. Position the panel in the desired location on
the fence frame and slide the screws (A) so
they are spaced evenly and aligned with the
predrilled holes in the top of the Fence frame.
The holes in the top of the
NOTE:
Fence frame are repeated every 3".
6. Place the screen firmly into the top channel of
the Fence frame, inserting the screws (A) through
the predrilled holes in the top of the Fence frame.
If more than one screen is to be
NOTE:
placed, be sure to slide adjoining screens
onto the protruding halves of the roll
pins (C) installed in step 3.
(B) 7473300 (B) 1A52247H02
7. Ensure the screen position is correct and modify,
if necessary. Tightly secure all screws (A) with
¼-20 serrated flange hex nuts (B), from inside
the frame, under the top horizontal channel.
8. Re-install the upper covers removed in Step 2.