Stanchion Mounted Storage For Big Table - Knoll Antenna Workspaces Installation Instructions Manual

Stanchion Mounted Storage for Big Table

Pattern Numbers Represented:
Stanchions for Big Table, YSUS_BT
Parts List:
Stanchion Extrusion (A)
Stanchion Base (B)
Stanchion Top Plate (C)
Spring Nut (D)
M6 X 25mm Machine Screw (E)
¼ - 20 x 1.75" Torx Head Self Tapping Screw, Zinc (F)
¼-20 x ½" Machine Screw (G)
Upmount Cabinet
Tools Needed:
Drill
Phillips #2 and #3 bits
Torx #10 bit
STEPS
1. Attach (1) stanchion extrusion (A) to each
stanchion base (B) using (2) ¼ - 20 x 1.75" Torx
head self tapping screws (F) per
stanchion base (B).
2. Attach (1) stanchion top plate (C) to
the top of each stanchion extrusion (A)
using (2) ¼ - 20 x 1.75" Torx head self
tapping screws (F) per top plate (C).
(A) 3AB405302*
(E) 3AB405540
3. Attach stanchion assembly top plates (C) to
the underside of the storage using (4) ¼-20
x ½" machine screws (G) per top plate.
4. Insert (4) spring nuts (D) into the top slot in the
center beam (i.e. (2) per stanchion base bracket).
5. Attach (2) stanchion extrusion/ stanchion
base assemblies loosely to the spring nuts
(D), using (2) M6 X 25mm machine screws
(E) per stanchion base (B). Do not tighten.
(B) 3AB4039* (C) 6AA4673*
(F) 4A2200396 (G) 7143440
6. Determine the desired storage cabinet position
along the width of the table, and adjust/slide
the location of the stanchion bases (B) along
the center beam so the holes in the stanchion
top plates (C) correspond with the predrilled
holes on the underside of the storage.
7. Tighten the screws (E) in the stanchion
bases (B) to the spring nuts (D) to secure
their locations on the center beam.
(D) 3AB402196