Laptop Drawer And Cable Net - Knoll Antenna Workspaces Installation Instructions Manual

Laptop Drawer and Cable Net

Pattern Numbers Represented:
Laptop Drawer, YSAD_G
Drawer Pad, YSADPAD_
Cable Net, YSAD_NET
Parts List:
Storage Hanging Bracket (A)
¼ - 20 x ½" Machine Screw with Washer (B)
¼- 20 x / " Set Screw (C)
3
8
Grommet (D)
Laptop Drawer Assembly
Lock Assembly
Drawer Liner (optional)
Additional Parts for Cable Net:
Cord Netting (E)
#8 x ½" Machine Screw (F)
Tools Needed:
Drill
Phillips #2 and #3 bits
/ " Allen Key
1
8
LAPTOP DRAWER INSTALLATION STEPS
1. Suspended storage should be attached prior to
the top being fastened to the base assembly.
2. Remove the drawer from the laptop
drawer assembly and set aside.
3. Attach (4) storage hanging brackets (A)
loosely to the top of the laptop drawer case
using (4) ¼ - 20 x ½" machine screws with
washers (B). They should be loose enough
to easily slide along the horizontal rails.
4. Place the attached hanging brackets (A)
around and on the rails. Determine the
position for the laptop drawer, and slide the
laptop case along the rails into position.
(A) 3AB4063*
Note: two views of bracket shown
3AB4063
(E) 3AB018502 (Shown for 21"D drawer)
3AB018501 (For 27"D drawer)
5. Once the laptop case is correctly positioned,
tighten the machine screws (B).
6. Use (4) set screws (C) to secure the hanging
brackets into position on the rails.
7. Insert (2) grommets (D) into the holes
at the back of the laptop drawer with
the injection nubs facing down.
8. (Optional) Place drawer liner into laptop
drawer, taking care to line the grommet holes
in the liner up with the holes in the drawer.
9. Replace the laptop drawer, along
its slides into its case.
10. Install laptop drawer lock assembly. (See
lock assembly instructions for details.)
(B) 7252140 (C) 4A2200740
(F) 4A22194
Additional Steps for Cable Net Installation:
11. Stretch the cord netting (E) along the
bottom of the laptop drawer case, so the
holes in the sides of the netting align with
the holes in the bottom of the case, and
attach using #8 x ½" machine screws (F).
A 21" drawer net will require (8) screws. A
27" drawer net will require (10) screws.
(D) 3AB8080