Knoll Antenna Workspaces Installation Instructions Manual page 30

Table of Contents

Advertisement

Big Table with Inset Intermediate Leg
Cradle
Leg
Big Table End Leg
Plan View of Big Table
with intermediate Leg
12. Slide center beam mounting bracket
C-clamps (F), (2) per center beam
mounting bracket (E), into slots on center
beam, pushing the C-clamps tightly
against the mounting brackets (E).
The C-clamps (F) must be installed.
NOTE:
13. If applicable, attach suspended storage,
returns and/or electrical components at this
time. (see suspended storage, big table with
return and electrical installation instructions)
Cradle
Horizontal Rail Cradle (A)
Center Beam
Center Beam
Bracket on
inner side of leg
Bracket on
inner side
of leg
Big Table End Leg
Big Table End Leg
Starter Rails
Cradles face each other
Plan View of Big table with Inset Intermediate Leg
Big Table with
Intermediate Leg
14. Lay tops on base assembly. Use install
gauge to properly position tops. See Install
Gauge Guidelines. Attach tops using (2)
#14 x 1" FH wood screws (M) per cradle
(A&H). Secure (2) flat brackets (J) to each
top-to-top connection using (4) #14 x 1"
FH wood screws (M) per flat bracket.
15. Surfaces 48" wide and greater require a spacer
(C) for additional support. When necessary,
a spacer should be placed between
Leg
Big Table Inset Intermediate Leg
Big Table Inset Intermediate Leg
Flat bracket (J)
Extended Rails
with (4) #14 x 1" FH
Wood Screws (M)
Inset Intermediate Leg
66
core, Dark Red or Slate Blue p
Cradle
Inset cradle adaptor assembly
Horizontal Rail Cradle (A)
Center Beam
Center Beam
Bracket on both
Bracket on
sides of leg
both sides
of leg
Big Table End Leg
Plan View of Big Table with
Insert Intermediate Leg
Cradles face starter rails
the top of each rail and the underside of
the top, centered on the width of the top.
Spacers are attached to the top using (1) #12
X ¾" black wood screw (D) per spacer.
16. Install center beam end caps, as
needed, to finish beam ends. (See
Center Beam End Cap instructions.)
17. Adjust glides as needed to level big
table assembly.
Center Bea
Bracket on
Leg
inner side
of leg
Big Table En
Big Table with I
Intermediate

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Knoll Antenna Workspaces

Table of Contents