Big Table Fabric Screens - Knoll Antenna Workspaces Installation Instructions Manual

Big Table Fabric Screens

Pattern Numbers Represented:
Fabric Screens for Big Table
Center Beam, YPSC__F
Parts List:
Bayonet Mount Bracket (A)
Spring Nut (B)
M6 X 25mm Machine Screw (C)
Screen
Tools Needed:
Drill
Phillips #2 and #3 bits
STEPS:
1. Insert (4) spring nuts (B) into the
top slot in the center beam (i.e. (2)
per bayonet mount bracket).
2. Attach (2) bayonet mount brackets (A) loosely
to the spring nuts (B), using (2) M6 X 25mm
machine screws (C) per bracket. Do not tighten.
(A) 3AB408200
3. Determine the desired screen position along the
width of the table, and adjust/slide the location
of the bayonet mount brackets (A) along the
center beam so they will correspond with the
openings on the underside of the screen.
4. Tighten the screws (C) in the bayonet mount
brackets (A) to secure their locations.
(B) 3AB402196 (C) 3AB405540
5. Position the openings in the underside
of the screen over the bayonet mount
brackets (A) and push the screen down
until the screen is firmly seated.