Knoll Antenna Workspaces Installation Instructions Manual page 49

Big Table with Extension Top or Cabinet
6. Lay tops on base assembly. Use install gauge
to properly position tops. See Install Gauge
Guidelines. Attach tops using (2) #14 x 1" FH
wood screws (K) per cradle (A). Secure (2) flat
brackets (H) to each top-to-top connection using
(4) #14 x 1" FH wood screws (K) per flat bracket.
7. Surfaces 48" wide and greater require a
spacer (C) for additional support. When
necessary, a spacer should be placed between
the top of each rail and the underside of
the top, centered on the width of the top.
Spacers are attached to the top using (1) #12
X ¾" black wood screw (D) per spacer.
Extended
Rail
Exploded Big Table with Extended Rails Detail
8. Secure main table desk top and extension
top or cabinet using W-brackets (O) and
end caps with support tabs (N) included
in connector kit YBTE. Use (4) #14 x 1" FH
wood screws (K) per W-bracket, and (1)
#14 x 1" FH wood screw per end cap.
8a. For extension top applications, attach
15" wide extension top using (4) #14 x
1" FH wood screws (K) per W-bracket.
Extended rail should be 4 ½" inset from
the outer edge of the extension top.
8b. For above desk extension cabinet
applications, place cabinet on top of rails
with (4) #14 x 1" FH wood screws (K) per
W-bracket. Extended rail should be 4 ½" inset
from the outer edge of the extension cabinet.
Center Beam
#14 x 1" FH Wood Screw (K)
Spacer
8c. For below desk extension cabinet
applications, slide cabinet on rails and
attach with (4) #14 x 1" FH wood screws
(K) per W-bracket. The top of this cabinet
should be on an even plane with the main
top. Extended rail should be 4 ½" inset from
the outer edge of the extension cabinet.
9. Install center beam end caps (full height and
partial height), as needed, to finish beam ends.
(See Center Beam End Cap instructions.)
10. Adjust glides as needed to
level big table assembly.
OPTIONAL STEP FOR FABRIC INSERTS:
11. Remove paper backing from double sided
adhesive tape. Place fabric inserts in the recess
behind the back of the extension cabinet,
pressing the four corners firmly to attach.
W-Bracket (O)
End Cap with
Support Tab (N)
Horizontal Rail
Cradle (A)
Desk End Leg
Top
Side
Bottom
Center Beam Orientation