Knoll Antenna Workspaces Installation Instructions Manual page 57

Electrical Components: Power for Big Table Center Beam
Pattern Numbers Represented:
Power Harness, YRPHE_, YR1PHT_
Duplex Receptacles, YR1D_
Outlet Fillers, YROF
Raceway Covers, YRC__
Raceway End Caps, YRCE
Jumper Cables, YR1EJ_, YR1TJ_
Parts List:
Bottom Power Harness Mounting Bracket (A)
Top Power Harness Mounting Bracket (B)
Spring Nut (C)
M6 x 70mm Machine Screw & Washer (D&E)
Power Harness
Duplexes
Jumper Cables
Raceway Covers
Raceway End Caps
Outlet Fillers
Tools Needed:
Drill
Phillips #2 and #3 bits
:
STEPS
1. Insert (2) spring nuts (C) into the bottom slot
in the center beam.
2. Insert bottom power harness mounting bracket
(A) into the bottom of the power harness.
3. Insert the top power harness mounting bracket
(B) into the top of the power harness.
(A) 3AB500800 (B) 3AB500100
(E) 3AB403500
4. Attach the two bracket (A/B) pairs and the
power harness to the center beam using
(1) M6 x 70mm machine screw & washer
(D&E) per pair. Each screw should be
threaded through a bottom mounting
bracket (A), the power harness, a top
mounting bracket (B), a washer, and lastly,
a spring nut (C) in the center beam.
5. Insert duplexes into the inner terminals
of the power harness as required.
6. Install jumper cables into the outer terminals
of the power harness as required.
: Arrows stamped into the molded
NOTE
plugs should be pointed up, indicating
proper orientation of the jumper cable.
(C) 3AB402196 (D) 3AB403496
7. Install raceway covers on both sides of
power harnesses by first aligning slotted
holes on the top of the raceway cover with
the tabs on top of the top power harness
mounting brackets (B). Swivel the cover
downward to engage the groove at the
bottom of the raceway cover with the bottom
lip of the bottom power harness mounting
brackets (A). Install outlet fillers (YROF) in
all unoccupied raceway knockout covers.
8. Install raceway end caps on raceway
covers for all power harness ends
without a connected jumper.